Building Energy and Comfort Optimization Open access

Thermal Performance, Heat Flux Distribution, and Primary Energy Implications of Active Heated Triple-Glazed Units: Localized vs. Full-Surface Operation

Hanna Koshlak, Аnatoliy Pavlenko, Jerzy Zbigniew Piotrowski, Anita Ciosek

Preprints.org | Nov 5, 2026

Abstract

Abstract

This study conducts a comparative empirical evaluation of spatial heat flux distribution, cavity thermofluid dynamics, and primary energy implications in an argon-filled triple-glazed unit (TGU) operating under localized bottom-edge perimeter heating (configuration I) and full-surface planar heating (configuration II) across outdoor temperatures ranging from -25 °C to +5 °C. Empirical boundary-layer measurements from a physical test specimen (Asample= 0.405 m2) were scaled to a standard architectural reference module (A = 2.5 m2). To establish a dimensionally valid comparison against whole-building regulatory NZEB limits, module energy demands were normalized by gross conditioned floor area using a representative fenestration-to-conditioned-floor-area ratio of 0.2. Results demonstrate that localized perimeter heating acts as an exergy-efficient micro-climate buffer, achieving a 34% reduction in inward heat loss when increasing the foil setpoint from 30 °C to 45 °C and effectively suppressing cold downdraughts while restricting floor-area-normalized primary energy demand to 11.4 kWh/m2∙yr (EPpoint = 143 kWh/yr total module demand across an 864 h duty cycle). In contrast, full-surface heating eliminates vertical thermal stratification and achieves spatial temperature homogeneity, but converts the glazing into an active space heater, driving high internal heat flux densities (182.1–234.5 W/m² at -25 °C) and an annual primary energy consumption of 1188 kWh/yr per module (EPplanar = 95.04 kWh/m2∙yr, representing an 8.3-fold increase compared to configuration I (143 kWh/yr total module demand). This 8.3-fold discrepancy confirms that unmodulated full-surface planar heating acts as a high-penalty primary energy load, requiring model predictive control architectures to decouple peak thermal capacity from cumulative primary energy constraints. Exterior glass surface temperatures remain thermally independent of internal heating across both regimes, and argon cavity Rayleigh numbers from 2.5 x 104 to 5 x 104 confirm a stable convective boundary-layer regime. To comply with nearly zero-energy building (NZEB) standards, an intelligent model predictive control strategy should maintain localized perimeter heating as a low-power baseline, dynamically escalating to full-surface heating only during extreme sub-zero climatic conditions.

Direct answer

What can I do from this paper page?

Use this page to scan "Thermal Performance, Heat Flux Distribution, and Primary Energy Implications of Active Heated Triple-Glazed Units: Localized vs. Full-Surface Operation" quickly: start with the summary and abstract, then check the authors, source, topics, and related papers. From here, open Scollr to follow Building Energy and Comfort Optimization research, save the paper, or map adjacent work.

Authors

Researchers on this paper

Hanna Koshlak

first | ORCID 0000-0001-8940-5925

Аnatoliy Pavlenko

middle | ORCID 0000-0002-8103-2578

Jerzy Zbigniew Piotrowski

middle | ORCID 0000-0002-8479-1406

Anita Ciosek

last | ORCID 0000-0002-5315-7058

Research areas

Follow related topics

Citation

BibTeX

@article{Koshlak2026Thermal,
  title = {Thermal Performance, Heat Flux Distribution, and Primary Energy Implications of Active Heated Triple-Glazed Units: Localized vs. Full-Surface Operation},
  author = {Hanna Koshlak and Аnatoliy Pavlenko and Jerzy Zbigniew Piotrowski and Anita Ciosek},
  journal = {Preprints.org},
  year = {2026},
  doi = {10.20944/preprints202611.0602.v1},
  url = {https://doi.org/10.20944/preprints202611.0602.v1}
}

FAQ

Using this paper in a discovery workflow

How do I find related work for this paper?

Use the related papers and topic links on this page as starting points. In Scollr, you can also open the paper and build a literature map around its references, citing papers, and related work.

How can I keep up with new Building Energy and Comfort Optimization research papers?

Follow Building Energy and Comfort Optimization research in Scollr. New papers from the topic flow into a personalized feed, and you can save useful studies to revisit later.

Can I cite this paper from this page?

This page includes a static BibTeX block for Thermal Performance, Heat Flux Distribution, and Primary Energy Implications of Active Heated Triple-Glazed Units: Localized vs. Full-Surface Operation. Always verify the DOI, source, and publication details against the publisher record before submitting a manuscript.

Follow this research in Scollr

Follow the topics and authors behind this paper, save useful studies, and build a literature map when you are ready to go deeper.

Get the app