Erosion and Abrasive Machining Open access Peer reviewed

Study on the Influence of Inlet Inclination Angle on the Erosion Characteristics of a Drilling Float Valve

Xin Zhang, Junan Lu, Yanwen Liu, Xitian Shi and 2 more

Processes | Nov 6, 2026

Abstract

Abstract

Localized erosion near the valve cover and pin shaft can impair the reliability of drilling float valve. This study investigates an eccentric contraction modification for a 62 mm float valve, in which the small-end cross-section is shifted away from the pin shaft while the diameters of both end sections remain unchanged. Computational fluid dynamics simulations incorporating the RNG k–ε turbulence model, discrete phase model, and Oka erosion model were conducted to investigate the erosion characteristics for inlet inclination angles of 4.5–8.5°. At a flow rate of 20 L/s, a solid volume fraction of 0.5%, and a drilling-fluid viscosity of 20 mPa·s, increasing the inclination angle from 4.5° to 8.5° reduced the average erosion rates of the valve cover and valve spool body by 94% and 51%, respectively. The modification redirected particle-laden flow away from these critical components and reduced concentrated particle impacts. The effects of particle size, fluid viscosity, and solid concentration were also examined. Comparative tests conducted for 15 h at 20 L/s and a sand volume fraction of 15% showed visibly less valve-cover damage for the structural optimization of float valve, providing qualitative support for the predicted improvement. An inclination angle of 8.5° is recommended within the investigated geometric and seal-installation constraints.

Direct answer

What can I do from this paper page?

Use this page to scan "Study on the Influence of Inlet Inclination Angle on the Erosion Characteristics of a Drilling Float Valve" quickly: start with the summary and abstract, then check the authors, source, topics, and related papers. From here, open Scollr to follow Erosion and Abrasive Machining research, save the paper, or map adjacent work.

Authors

Researchers on this paper

Xin Zhang

first

Junan Lu

middle

Yanwen Liu

middle

Xitian Shi

middle

Xuliang Zhang

middle | ORCID 0000-0002-8952-8009

Lin Zhong

last | Southwest Petroleum University | ORCID 0000-0001-6823-8371

Research areas

Follow related topics

Citation

BibTeX

@article{Zhang2026Study,
  title = {Study on the Influence of Inlet Inclination Angle on the Erosion Characteristics of a Drilling Float Valve},
  author = {Xin Zhang and Junan Lu and Yanwen Liu and Xitian Shi and Xuliang Zhang and Lin Zhong},
  journal = {Processes},
  year = {2026},
  doi = {10.3390/pr14213589},
  url = {https://doi.org/10.3390/pr14213589}
}

FAQ

Using this paper in a discovery workflow

How do I find related work for this paper?

Use the related papers and topic links on this page as starting points. In Scollr, you can also open the paper and build a literature map around its references, citing papers, and related work.

How can I keep up with new Erosion and Abrasive Machining research papers?

Follow Erosion and Abrasive Machining research in Scollr. New papers from the topic flow into a personalized feed, and you can save useful studies to revisit later.

Can I cite this paper from this page?

This page includes a static BibTeX block for Study on the Influence of Inlet Inclination Angle on the Erosion Characteristics of a Drilling Float Valve. Always verify the DOI, source, and publication details against the publisher record before submitting a manuscript.

Follow this research in Scollr

Follow the topics and authors behind this paper, save useful studies, and build a literature map when you are ready to go deeper.

Get the app